Raised Wall Panelling Kit For Stairs

The raised panel stair kit is made up of moulded stiles and rails in loose components and a 5 piece raised panel. In order to fit the pitch of the stairs, the panels and stiles are oversized and need to be cut to suit the specific stair. Each kit in crafted from Moisture Resistant MDF and is ready primed for painting to match your décor.  

Kit Sizing

Each kit consists of 3 - 2.2m x 122mm horizontal rails, 110mm x 1m stiles that have to be cut to stair pitch (with 45 degree tilt on chop saw), 16 x 1m lengths of rebated fielding (71mm x 12mm) and 4 x  9mm panels (800mm x 405mm.)

Installation

To install, calculate the pitch of the stairs and cut the both the top and bottom of the stiles and rails to suit the stair pitch. The maximum width between the stiles is 495mm however this can be reduced if needed.

Once the stiles are fitted and the panel widths calculated the 9mm panels are cut in width and then cut top and bottom to the stair pitch, the rebated fielding is then cut and assembled around each panel, these are then fitted into the openings between the stiles completing the raised panelling.